HP StorageWorks 600 - Modular Disk System User Manual page 17

Slide the rack rail closed until the end of the rail is locked in place, wrapping behind the rear rack
2.
column.
Slide the front end of the rail to the rack front column. When fully seated, the rack rail will lock into
3.
place.
Repeat the procedure for the right rack rail.
4.
WARNING: The HP MDS600 Disk System is very heavy. To reduce the risk of personal injury
or damage to the equipment:
• Observe local occupational health and safety requirements and guidelines for manual
material handling.
Remove all installed HP MDS600 Disk System components from their HP MDS600 Disk
•
Systems before installing or moving the HP MDS600 Disk Systems.
Use caution and get help to lift and stabilize HP MDS600 Disk Systems during installation
•
or removal, especially when the HP MDS600 Disk System is not fastened to the rack.
WARNING: Always use at least two people to lift an enclosure into the rack. If the enclosure
is being loaded into the rack above chest level, a third person must assist with aligning the
enclosure with the rails while the other two people support the weight of the enclosure.
Setup 17