Enterasys Intrusion Prevention System Manual page 40

Configuring the Application Filter Module
4. Click the Port Settings tab.
5. To configure an Ignored Port or an Ignored Port Range, click the Add button located below the
appropriate table.
Or, alternatively, you can click the Edit All button to display the Edit All Ignored Ports text
editing window and enter the desired port information as text strings.
6. Enter the number of a specific port to ignore, or the numbers of the beginning and end ports in
a range of ports to ignore. Port numbers can range from 1 to 65535. Refer to
page 2-8 for a list of common port numbers.
7. Specify the Direction of the traffic to ignore:
–
–
–
–
8. Click OK. The values are displayed in the table.
9. Click Commit to add your changes to the policy being configured.
2-10 Creating Network Sensor Policies
any: Ignore the traffic if the port is the source or destination port.
source: Ignore the traffic if the port is the source port.
destination: Ignore the traffic if the port is the destination port.
both: Ignore the traffic if the port is the source and destination port.
Table 2-1 on