Enterasys Intrusion Prevention System Manual page 103

a. Select the type of port to add or exclude, then enter the port number or low and high
numbers for a range. Refer to
b. Select the direction of the traffic to be analyzed and click OK.
8. To add a Port Macro to the port list, click Add PortMacro. The Port Macro Selection dialog
box is displayed. Select the desired macro and click OK.
Note: To display existing port macros and their definitions, or to add a new macro, click Default
Network Sensor Settings in the Network Policies tab of the Network Policy View. See
"Configuring Port
9. Click Commit to add your changes to the policy being configured.
Table 2-1
Macros" on page 1-14 for information about creating or editing port macros.
Configuring the Protocol Analysis Module
on page 2-8 for a list of common port numbers.
Creating Network Sensor Policies and Signatures 2-73