Table of Contents
Advertisement
Intel® Entry Server Board SE7221BK1-E User Guide
6. Move the BIOS recovery jumper at J1F2 back to the original position, covering pins
9 and 10.
7. Plug the system into the AC power source and power it up to confirm that the recorvery
was successful.
NOTE
To use splitter.exe type the following command at the command prompt:
split AMIBOOT.ROM AMIBOOT 1024
The above command will create the files of sizes 1MB each with names
AMIBOOT.000, AMIBOOT.001... and so on, depending upon the
AMIBOOT.ROM file size.
Load the first disk with AMIBOOT.000. It will search the same disk for
AMIBOOT.001 If doesn't find the file in the floppy it will beep for one (1)
second and search again.
Clearing the Password
If the user or administrator password(s) is lost or forgotten, moving the password clear jumper into
the "clear" position clears both passwords. The password clear jumper must be restored to its
original position before a new password(s) can be set. The password clear jumper is located on
jumper block J1F2.
1. Power down the system and disconnect the AC power.
2. Open the server chassis.
3. Move the jumper from pins five and six to the Clear Password position, covering pins
six and seven.
4. Reconnect the AC power, power up the system.
5. Power down the system and disconnect the AC power.
6. Return the Password Clear jumper to the spare location, covering pins five and six.
7. Close the server chassis.
Clearing the CMOS
If you are not able to access the BIOS setup screens, the CMOS Clear jumper will need to be used
to reset the configuration RAM. The CMOS Clear jumper is located on jumper block J1F2.
1. Power down the system and disconnect the AC power.
2. Open the server.
3. Move the jumper from pins one and two to the Clear CMOS position, covering pins
two and three.
4. Reconnect the AC power, power up the system.
5. When the system begins beeping, power it down and disconnect the AC power.
6. Return the CMOS Clear jumper to the original location, covering pins one and two.
7. Close the server chassis, reconnect the AC power and power up the system.
26
Server Utilities
Advertisement
Table of Contents
