System Boots When Installing Pci Card - Intel S5000VCL - Server Board Motherboard User Manual

Diagnostics pass but the connection fails
•
Make sure the network cable is securely attached.
•
Make sure you specify the correct frame type in your NET.CFG file.
•
The controller stopped working when an add-in adapter was installed.
•
Make sure the cable is connected to the port from the onboard network controller.
•
Make sure your BIOS is current. See
link to the current version.
•
Make sure the other adapter supports shared interrupts. Make sure your operating
system supports shared interrupts.
• Try reseating the add-in adapter.
The add-in adapter stopped working without apparent cause
•
Reseat the adater.
•
Put the adapter in a different slot.
•
The network driver files may be corrupt or deleted. Delete and then reinstall the
drivers.
• Run diagnostics.

System Boots when Installing PCI Card

System Server Management features require full-time "standby" power. This means some
parts of the system have power going to them whenever the power cord is plugged in,
even if you have turned the system power off with the power button on the front panel. If
you install a PCI card with the AC power cord plugged in, a signal may be sent to
command the system to boot. Before installing a PCI card, you should always:
•
Turn off the server power by using the power button on the front of the system.
• Unplug the AC power cord(s) from the server.
42
"Additional Information and Software"
Intel® Server Board S5000VCL User Guide
for a