Troubleshooting Table - Electrolux HC 60/70 / PH 6HC 60/70 / PH 611 Instruction Manual

Make sure the STOP switch is on I.
Make sure that the fuel tank is at least 25%
full.
Make sure the air filter is clean.
Remove the sparkplug, dry and clean it,
then return it to its place. If necessary,
replace it.
Check and if necessary adjust the screws
on the carburetor
Change the fuel filter. Contact your supplier.
Follow the correct procedure for assembly
of the cutting accessories.
Make sure the metal accessories are sharp,
and contact your supplier if necessary.
The engine continues to have problems: contact your authorized supplier.
This section contains information useful for main-
taining the characteristics of eco-compatibility
included in the origin design of the machine, and
as regards proper use and disposal of oil and
fuel.
1. DESIGN
In the design stage, care was taken to develop an
engine with reduced consumption and low emis-
sions of noise and pollutant exhaust fumes.
2. USE OF MACHINE
The operations of filling the tank with the fuel mix-
ture should be carried out in such a way as to
avoid spilling fuel and contaminating the soil and
environment.
ENGLISH - 8

Troubleshooting table

The engine
does not
start
•
•
•
•
Environmental information
3. PERIODS OF PROLONGED DISUSE
Always empty the fuel tank with the same precau-
tions used in filling it.
4. DISPOSAL
Do not dispose inappropriately of the machine
when it is no longer usable. Deliver it to an
authorized organization for proper disposal in
compliance with the regulations in force.
The engine stutters
or loses power
•
•
•
•
•
The machine
starts but does
not cut properly
•
•