Chapter 1
Disk Spacers
When your hot-swap cage holds a mix of low profile and half-height drives, one
drive may require a disk spacer. The disk spacer fills empty space between one
drive and the adjacent drive. Disk spacers can be mounted on 1-inch (2.5 cm) low
profile drives or 1.6-inch (4 cm) half-height drives. (Figure 2-2 in the next chapter
shows a disk spacer.)
Verify Contents
The Ultra3 SCSI Hot-swap Hard Disk Drive and Tray Accessory Kit contains the
following items:
Ultra3 SCSI hot-swap hard disk drive module
disk spacer
Ultra3 SCSI Hot-swap Hard Disk Drive and Tray User Guide
If anything is missing or damaged, call your reseller.
2
Introduction to Ultra3 Drives