Installing The Ultra3 Drive In A Tray (Optional) - HP D7171A - NetServer - LPr User Manual

Chapter 2
Figure 2-6. Removing the Disk Drive Module

Installing the Ultra3 Drive in a Tray (optional)

Ultra3 SCSI hot-swap tray accessories have two different sizes: the 1.6-inch
(4 cm) half-height drive uses tray accessory D6127A, and the 1-inch (2.5 cm) low
profile drive uses tray accessory D6128A. (These tray accessories also support
Ultra2 drives.)
CAUTION
Handle the drive and tray gently during assembly. Start all
screws prior to tightening. Do not allow the drive or the tray to
drop; dropping the drive or tray will cause drive damage.
If you purchase an Ultra3-SCSI hot-swap tray accessory separately from the Ultra3
drive, refer to Figure 2-7 and follow these steps to attach the tray accessory:
1. Place the Ultra3 drive into the hot-swap tray.
Installation Procedure
9