Overview - HP D7171A - NetServer - LPr Installation Manual

2 Overview

The steps required to install the NetServer in the rack are summarized below:
NOTE
This is only a summary; detailed instructions are provided on the
following pages.
Measure and mark the appropriate holes on all four rack columns.
Install four rack nuts on each of the two front rack columns.
Insert two rack nuts on each of the two rear rack columns.
Attach the slides to the columns.
Extend the slides.
Remove power supply modules from the NetServer.
Lift the NetServer onto the slides.
Secure the NetServer to the slides.
Remove the lifting handles from the NetServer.
Install the power supply modules in the NetServer.
Push the NetServer back into the rack enclosure.
Secure the NetServer to the two front columns.
5