HP D7171A - NetServer - LPr Installation Manual page 17

Chapter 3
Pull Handle Down
Figure 3-5. Removing a Power Supply Module
WARNING
This NetServer weighs up to 160 pounds (73 kg.) when fully
configured. Remove all power supply modules and hot-swap
hard disk drives before lifting the NetServer.
Use two people when moving the NetServer or lifting it into
the rack.
3. Using two people, lift the NetServer using the handles on each side. Move
the NetServer in between the extended slide members and position it so
that the handles are resting on the slide members (see Figure 3-6 and
Figure 3-7).
Installation
Power
Supply
Module
Pull Module Out
13