HP D7171A - NetServer - LPr Software Install Manual page 30

Use a spare PC running DOS, OS/2 or NT to complete the following tasks. Please read
"Consideration 1" in Section 1 of this document and complete the table in that section before
you proceed with this step.
A) If you have an HP DAC, find the lines that read:
basedev=dac960.add
basedev=ibm1s506.add
basedev=aic7870.add
Remark them out with the REM command as follows: (Note that this step is done to avoid
boot order issues. See "Consideration 1" in Section 1 for details.)
rem basedev=dac960.add
rem basedev=ibm1s506
rem basedev=aic7870.add
Add three lines to the start of CONFIG.SYS as follows:
basedev=ibm1s506.add
basedev=hpda.add
basedev=aic7870.add
B) If you have an HP NetRAID, replace the lines that read:
basedev=ibm1s506.add
basedev=aic7870.add
with:
rem basedev=ibm1s506
rem basedev=aic7870.add
Add three lines to the start of CONFIG.SYS as follows:
basedev=ibm1s506.add
basedev=mraid.add
basedev=aic7870.add
C) While editing CONFIG.SYS, locate and delete any lines that look like the one's you've
added which are calling the same drivers. You don't want duplicate driver names. This can
cause Trap 00D or Trap 00E during the OS/2 boot process.
D) While editing CONFIG.SYS on the "Work Diskette 1". Locate the section with all the
30