HP D7171A - NetServer - LPr Software Install Manual page 31

IBM type 2 drivers, as follows:
basedev=ibm2flpy.add
basedev=ibm2adsk.add
basedev=ibm2scsi.add
Remark out those driver lines using the REM command, since they are not needed, so that
they read as follows...
REM basedev=ibm2flpy.add
REM basedev=ibm2adsk.add
REM basedev=ibm2scsi.add
E) While editing the CONFIG.SYS file, locate the Adaptec drivers section with the following
Adaptec driver lines:
basedev=aha154x.add
basedev=aha164x.add
basedev=aha174x.add
Remark out these lines by adding the REM command so they read as follows...(make sure
you have no need for any of these drivers before implementing this step).
rem basedev=aha154x.add
rem basedev=aha164x.add
rem basedev=aha174x.add
4. Copy required drivers to "Work Diskette 1" use a spare PC running DOS, OS/2, or NT to
complete the following tasks:
A) Create a temporary directory on the hard disk of the workstation you are using, by
entering (if you created the C:\HPTEMP directory in step 13 of "Section 2" then skip the MD
HPTEMP command):
C:
MD HPTEMP
CD HPTEMP
B) Insert the "Drivers/Utilities" diskette in drive A of the workstation, and enter the
following copy commands:
COPY A:\7800\AIC7870.ADD
COPY A:\7700\AIC7770.ADD
COPY A:\HPDA\HPDA.ADD
COPY A:\NETRAID\MRAID.ADD
31