HP D7171A - NetServer - LPr Software Install Manual page 22

following driver is present in CONFIG.SYS:
basedev=mraid.add
basedev=aic7870.add
9. Complete the OS/2 Installation GUI screen. Select VGA for the video driver. Do not change
the SCSI configuration.
Remove the Work Diskette from drive A, and press Enter to reboot the machine and continue
with OS/2 installation.
CAUTION: At the System Configuration Screen, the SCSI Adapter
selection may read "none". In this case, do not select a controller from the
pull-down menu. The UPDATE.EXE utility will add the correct driver in
step 11.
OS/2 will boot to the System Configuration Screen. It is important that you set the video
display configuration to VGA and that you leave the SCSI Adapter configuration to
"None". The other configuration parameters can be set to what you think is appropriate
for your system.
10. If you are installing Warp Connect select "NO" to install networking products. They can be
installed later after the base product is completely up and running. If you are installing
Warp Server 4.0 go to step 13.
Phase 5: Second Reboot
11. This step is a must do for the LS, LX. See Table 3 in "Section 2". You can skip it for any
other model by doing what the OS/2 installation program is requesting on the display and go
to step 13.
DON'T REBOOT THE SYSTEM when the installation completes.
A) This step is a must do for the LS, LX. See Table 3 in "Section 2". You can skip it for
any other model by doing what the OS/2 installation program is requesting on the display and
go to step 13.
After OS/2 Installation finishes and you are prompted to click OK to reboot, do NOT reboot.
Using the mouse, open the System Folder. Open the Command Prompts Folder. Start an
OS/2 Full Screen session. Make sure the drive letter shown at the prompt corresponds to the
drive where OS/2 is being installed.
Insert the Work Diskette in drive A and enter:
A:\UPDATE
22