HP D7171A - NetServer - LPr Software Install Manual page 23

Manual Process:
B) If you have an HP DAC verify that the following drivers are present in CONFIG.SYS. If
they are not present you must add them. Please keep in mind the order of drivers as listed in
Section 2.
basedev=hpda.add
basedev=aic7870.add
C) If you have an HP NetRAID, or if you don't have any disk array installed, verify that the
following driver is present in CONFIG.SYS:
basedev=mraid.add
basedev=aic7870.add
12. Enter the following command:
Exit
This will close command prompt session. Click OK at the GUI screen to reboot the system.
13. Congratulations! You have completed the OS/2 Warp installation. The system should reboot
and start running the tutorial utility. You can start testing OS/2 and, if you are installing OS/2
Warp Connect, you are now ready to install the networking products from the CD-ROM.
Additional steps are required if you are installing Warp Server 4.0
14. Make all necessary system and network selections at this time. OS/2 installation will
continue.
15. This step is a must do for the LS, LX. See Table 3 in "Section 2". You can skip this section
for any other model by doing what the OS/2 installation program is requesting on the display
and go to step 24.
PAY ATTENTION FOR THE FIRST AUTOMATIC REBOOT.
CAUTION: This is the potential problem listed in "Section 1," Issue 6.
After the first auto-reboot during the file and print installation section the
system may stop with an error when loading drivers in CONFIG.SYS the
error will read like this "Invalid path specified in line xy
c:\cid\log\instu\srvrexx.exe".
The system will reboot automatically more than once. You need to pay attention for the first
automatic reboot. When the system reboots you need to observe the screen for a white box to
appear at the upper left corner of the display. When you see this white box, press Alt and F1
simultaneously.
23