HP D7171A - NetServer - LPr Software Install Manual page 27

Device Support", Select "Non-Listed IDE CD-ROM" from the list, next deselect "OTHER".
6. Complete the OS/2 setup and Installation screen. Select the options that you want. Select
Next to continue.
7. Click OK on the Advanced options screen to accept "Add existing programs to the desktop".
8. Complete the Networking Product configuration.
You must configure networking products. There is no way to skip this section like in Warp
Connect. However, there is a loopback Network driver available on the list which you can
use if the NIC is not currently installed on the system or you can add your NIC driver at this
time. (You may select no for file and print services but the system will still force you to
install LAPS.)
The Warp Server SMP4.0 will ask for more configuration information than the Warp 4.0.
Please check your IBM installation manual for more details on those configuration questions.
The following steps are provided for guidance only. For example Warp Server for SMP will
ask for:
First Name: Last Name:
Department: Company:
etc.
9. Complete configuration screen that shows a tree view of the tasks to complete. The arrows in
red are must do items.
10. You must configure your adapter and the user ID. When done with the configuration panel
click Install to begin the installation routine. Click OK to confirm.
11. The system will take about 25 minutes transferring files to your hard drive. You will see the
screen "Updating system configuration" . When prompted select OK to install using default
monitor type.
Phase 4: Networking products Auto-Reboot two times
12. System will take about 5 minutes transferring files to the hard drive. Next an auto-reboot will
occur. Remember to remove the NIC driver diskette from drive A: if one was used to avoid a
boot error.
13. The system will reboot with the following message:
Locked files device driver
Processing locked files
27