Connecting The San Switch 2/32 To The Fabric - HP StorageWorks 2/32 - SAN Switch Installation Manual

Installing the SAN Switch 2/32

Connecting the SAN Switch 2/32 to the Fabric

Use these steps to connect the SFPs and cables to SAN Switch 2/32 ports as
required.
Note:
For a list of these requirements, refer to the
3.0.x/4.0.x User Guide
1. Remove the shipping plug from the appropriate ports.
2. Position the SFP so that the key (the tab near the cable-end of the SFP) is on
3. Insert the SFP into the port until it is firmly seated and the latching
Note:
the port. If the SFP does not slide in easily, check the orientation.
4. Connect the cables to the SFPs as appropriate to the fabric topology, by
56
The ports and cables used in trunking groups must meet specific requirements.
.
top.
mechanism clicks.
The SFP is keyed so that it can only be inserted with the correct orientation into
positioning each cable so that the key (the ridge on one side of the cable
connector) is aligned with the slot in the SFP; see
HP StorageWorks ISL Trunking Version
Figure
SAN Switch 2/32 Installation Guide
15.