Leds On The Non-Port Side Of The San Switch 2/32; Leds On Non-Port Side Of San Switch 2/32 - HP StorageWorks 2/32 - SAN Switch Installation Manual

Table 4: Front Panel LED Patterns During Normal Operation (Continued)
LED Name
Location
Port Status
LED
(continued)
Port Speed
LED

LEDs on the Non-Port Side of the SAN Switch 2/32

The non-port side of the switch contains the following LEDs, see
1
2
Figure 17: LEDs on non-port side of SAN Switch 2/32
Table 5
SAN Switch 2/32 Installation Guide
and LED
Location
Location
(continued
)
Above
each port,
on right
One Port Readiness LED on right side
One Power Supply LED next to the AC power switch on each power supply
One Fan Failure LED at the top of each fan assembly (inside the bezel)
2
1
Power supply LED
Fan failure LED
describes the LEDs on the non-port side of the switch.
Color Hardware
Display Status
Alternating Port is bypassed.
green and
orange
No light The port is
transmitting/
receiving at 1
Gbps.
Steady The port is
green transmitting/
receiving at 2
Gbps.
Port readiness LED
3
Managing the SAN Switch 2/32
Recommended
Action
Reset the port from
a management
station or check
configuration of
the Fibre Channel
loop.
No action
required.
No action
required.
Figure 17:
3
SHR-2579A
65