Removing Simple San Connection Manager; Removing Simple San Connection Manager In Windows; Installation Wizard: Initial Window For Program Removal - HP StorageWorks 1000 - Modular Smart Array User Manual

The following is returned:
qla2xxx_conf
qla2xxx
scsi_mod
c. To verify that the correct driver is loaded, issue the following command:
# cat /proc/scsi/qla2xxx/* | grep "Driver version"
The following is returned:
Firmware version: 3.03.25 IPX
Driver version: 8.02.02-fo

Removing Simple SAN Connection Manager

The Simple SAN Connection Manager uses the installation wizard to remove all components currently
installed. You must reboot your computer following program removal. Follow the procedure for removing
Simple SAN Connection Manager from Windows (page 26) or Linux (page 27).

Removing Simple SAN Connection Manager in Windows

Follow these steps to remove the Simple SAN Connection Manager software from a server running
Windows.
To remove Simple SAN Connection Manager in Windows:
1. Insert the installation CD into your computer's CD-ROM drive.
The HP Installation Wizard starts automatically.
The initial installation window
Figure 9

Installation wizard: initial window for program removal

2. Click Remove Programs.
A message box asks if you are sure you want to remove the program.
3. Click Yes to proceed with program removal, or No to cancel.
26 Installing, upgrading, and removing Simple SAN Connection Manager
303752 1
982688 0
445298 qla2xxx
(Figure 9) opens.