Configuring Simple San Connection Manager For Hp-Ux And Emulex Hbas; Hp-Ux Configuration - HP StorageWorks 1000 - Modular Smart Array User Manual
Hp storageworks simple san connection manager user guide (5697-0083, august 2009)
Hide thumbs
Also See for StorageWorks 1000 - Modular Smart Array:
- Administrator's manual (189 pages) ,
- Reference manual (83 pages) ,
- Specification (49 pages)
Table of Contents
Advertisement
4.
If the following message appears at the end of the installation, you must restart the computer, otherwise,
continue with
New driver and qlremote installed but not active.
For new driver and qlremote to be active either:
Reboot the system (Mandatory in case of Boot From SAN)
or
Stop all the applications using QLogic driver.
Unload QLogic driver by executing following command:
# modprobe -r qla2XXX (ex. qla2300, qla2400)
Reload new driver by executing following command:
# modprobe -v qla2xxx
Start qlremote as follows:
# /etc/init.d/qlremote start
Rebooting the system will automatically load new driver and start qlremote.
5.
To install the Linux driver with Fabric Device Management Interface (FDMI) enabled (by default, FDMI is
disabled), issue the following command:
# modprobe -v qla2xxx ql2xfdmienable=1
6.
To verify that the installation completed, check the FC HBA driver version:
a. To ensure that the driver is installed in the correct location, issue the following command:
# modinfo qla2xxx
The following is returned:
Filename: /lib/modules/2.6.9-55.ELsmp/kernel/drivers/scsi/qla2xxx/qla2xxx.ko
Version: 8.02.02 653675A771C3619AEEA4E9A
b. To verify that the driver is loaded, issue the following command:
# lsmod | grep qla2xxx
The following is returned:
qla2xxx_conf
qla2xxx
scsi_mod
c. To verify that the correct driver is loaded, issue the following command:
# cat /proc/scsi/qla2xxx/* | grep "Driver version"
The following is returned:
Firmware version: 3.03.25 IPX
Driver version: 8.02.02-fo
Configuring Simple SAN Connection Manager for HP-UX and Emulex
HBAs
Simple SAN Connection Manager is compatible with the HP-UX operating system and Emulex HBAs when
configured as described in this section.
HP-UX configuration
Simple SAN Connection Manager can manage all of your supported HP-UX servers. The HP-UX operating
system provides native software drivers for the HP StorageWorks FC HBAs. In order for the application to
properly identify your server(s), you must manually enter the Fabric Device Management Interface (FDMI)
information when the application prompts for it. For details, see
page 81.
20
Installing, upgrading, and removing Simple SAN Connection Manager
step
6:
303752
1
982688
0
445298
qla2xxx
"Manually entering FDMI information"
on
Advertisement
Table of Contents
