Output Retry Log Function; Fal_Retry_Target Environment Variable - HP StorageWorks P9000 User Manual

FAL_RETRY_WAIT_TIME
Others
FAL_RETRY_TARGET. You can set up to five system error codes to trigger the retry function by specifying
the environment variable (FAL_RETRY_TARGET). If you set six or more error codes, Data Exchange
ignores entries after the fifth entry.
Table 13 on page 41 shows the relationship between the environment variable (FAL_RETRY_TARGET)
and system error code.
CAUTION:
OS error codes returned in case of a reservation conflict may vary depending on the host environment,
such as the OS or HBA driver, timing of the conflict, and so on. You should do adequate testing before
determining any non-default error codes as triggers for the retry function. In case of a system error
other than the default value, contact HP technical support.
Table 13 FAL_RETRY_TARGET Environment Variable
FAL_RETRY_TARGET
No definition of environ-
ment variable
System error, system er-
ror, system error, system
error...
Other

Output Retry Log Function

Data Exchange outputs a retry log in the FAL_Error log file when retry is executed.
42 shows the retry log format.
System Error Codes That Trigger Retry
AIX
Tru64
Solaris
Linux
HP-UX
Windows
You can set up to five system error codes using a
comma (,) to separate the error codes.
No definition of environment variable
HP StorageWorks P9000 Data Exchange User Guide
Interval of Retry
1 second
16(EBUSY)
5(EIO)
22(EINVAL)
13(EACCES)
170(ERROR_BUSY)
Notes
–
16(EBUSY), 5(EIO),
22(EINVAL), 13(EAC-
CES), 170(ERROR_BUSY)
already included in each
OS.
–
Figure 21 on page
41