Viewing Replication Properties, Addresses, And Images For A Volume - HP P2000 Reference Manual

If the primary system comes back online, you can set its volume to be the primary volume again.
To change the secondary volume to the primary volume
1. On the secondary system, in the Configuration View panel, right-click the secondary volume and select
Provisioning > Set Replication Primary Volume.
2. In the main panel, select the secondary volume in the list.
3. Click Set Replication Primary Volume. A message indicates whether the task succeeded or failed. If it
succeeded, in the Configuration View panel the volume's designation changes from Secondary Volume
to Primary Volume.
NOTE: The offline primary volume remains designated a Primary Volume.
To change the primary volume back to the original primary volume
1. On the primary system:
a. Create a standard snapshot
b. In the Configuration View panel, right-click the primary volume and select Provisioning > Set
Replication Primary Volume.
c. In the main panel, select the primary volume in the list.
d. Click Set Replication Primary Volume. A message indicates whether the task succeeded or failed.
2. On the secondary system:
a. Replicate the secondary volume
will replicate any data changes made in the secondary volume back to the original primary volume.
NOTE:
and compare them to verify any discrepancies.
b. In the Configuration View panel, right-click the secondary volume and select Provisioning > Set
Replication Primary Volume.
c. In the main panel, select the primary volume in the list.
d. Click Set Replication Primary Volume. A message indicates whether the task succeeded or failed.
3. On the primary system:
a. In the Configuration View panel, right-click the primary volume and select Provisioning > Set
Replication Primary Volume.
b. In the main panel, select the primary volume in the list.
c. Click Set Replication Primary Volume. A message indicates whether the task succeeded or failed. If
it succeeded, in the Configuration View panel the primary volume is designated the Primary Volume
and the secondary volume is re-designated the Secondary Volume.

Viewing replication properties, addresses, and images for a volume

In the Configuration View panel, right-click a volume and select View > Overview. The Volume Overview
table shows:
• As described in
volume; the quantity of mappings for the volume; and the quantity of task schedules for the volume
• The quantity of replication addresses for the volume
• The quantity of replication images for the volume
For descriptions of storage-space color codes, see
Select a component to see more information about it.
(page
(page 1
An administrator can mount/present/map this snapshot and the snapshot taken in
Viewing information about a volume
67) to preserve the primary volume's last data level.
14) to synchronize at the last valid common sync point. This
on page 95: the capacity and space usage of the
About storage-space color codes
HP P2000 G3 MSA System SMU Reference Guide 121
step 1
on page 33.