Connecting The Network Cable - Kyocera TASKalfa 820 Operation Manual

4
Turn the main power switch of this machine ON ( | ).
For details on setting of each interface, refer to the
Functions Edition.

Connecting the network cable

When using this machine as a network printer, use a network cable (10Base-T or 100Base-TX) to
connect this machine to a network.
1
Turn the main power switch located on the rear left of
this machine OFF (
2 Connect the network cable to the network interface
connector located on the rear right of this machine.
3 Connect the other side of the network cable to the hub (concentrator).
4
Turn the main power switch of this machine ON ( | ).
5 Perform the network setting.
For details, refer to Setting the network (TCP/IP) on page 2-6.
).
Set-up
5