Figure 51 Advanced > Quality Of Service > Qos Classification; Table 37 Advanced > Quality Of Service > Qos Classification - ZyXEL Communications P-663H-51 User Manual

Chapter 9 Quality of Service (QoS)
Figure 51 Advanced > Quality of Service > QoS Classification
The following table describes the labels in this screen.
Table 37 Advanced > Quality of Service > QoS Classification
LABEL
Class Name
MARK
DSCP Mark
Queue ID
802.1P Mark
TRAFFIC
CLASSIFICATION
RULES
Lan Port
Protocol
DSCP
Source Addr./Mask
Source Port
Dest. Addr./Mask
Dest. Port
Source MAC Addr./
Mask
Dest. MAC Addr./
Mask
802.1P
Order
Enable / Disable
Remove
Add
Remove
Save/Apply
94
DESCRIPTION
This is the name of the classifier.
These columns are the QoS setting the ZyXEL Device uses for or assigns to the
packets of upstream traffic that match this QoS classifier.
This is the DSCP mark the ZyXEL Device assigns to the packets of upstream
traffic that match this QoS classifier.
This is the QoS queue the ZyXEL Device uses for the packets of upstream traffic
that match this QoS classifier.
This is the IEEE 802.1p mark the ZyXEL Device assigns to the packets of
upstream traffic that match this QoS classifier.
These columns identify the upstream traffic to which the QoS classifier applies.
This is the source Ethernet port of the traffic.
This is the type of packets.
This is the DSCP mark.
This is the IP address (and optionally the subnet mask) of the device that sent
the traffic.
This is the port number that a device used to send the traffic.
This is the IP address (and optionally the subnet mask) of the device that the
traffic is going to.
This is the port number on a device to which the traffic is going.
This is the MAC address (and optionally the subnet mask) of the device that sent
the traffic.
This is the MAC address (and optionally the subnet mask) of the device that the
traffic is going to.
This is the IEEE 802.1p mark on the traffic.
This is the classifier's place in the classifiers list.
The classifier is active when this check box is selected.
To remove an entry, select its Remove check box and click the Remove button.
Click this button to go to a screen where you can configure settings for a new
QoS queue.
To remove an entry select its Remove check box and click the Remove button.
Click this button to save the changes and have the ZyXEL Device start using
them.
P-663H-51 User's Guide