Panasonic Lumix DMC-GF3 Basic Owner's Manual page 99

In Program AE Mode, you can change the preset aperture value and shutter speed without
changing the exposure. This is called Program Shift.
You can make the background more blurred by decreasing the aperture value or record a
moving subject more dynamically by slowing the shutter speed when taking a picture in
Program AE Mode.
1
Press the shutter button halfway and display the
aperture value and shutter speed value on the screen.
2
While the values are displayed (about 10 seconds),
perform the Program Shift by rotating the control dial.
•
During display of the numerical values, each press of the
cursor button 3 switches between Program Shift and Exposure Compensation (P76).
•
Rotate the control dial to display the [EXPO.METER] B.
•
The Program Shift indication
•
To cancel Program Shift, turn the camera off or rotate the control dial until the Program
Shift indication disappears.
∫ Example of Program Shift
[When the interchangeable lens (H-H014) is used]
(A): Aperture value
(B): Shutter speed
1 Program Shift amount
2 Program Shift line chart
3 Program Shift limit
Note
•
EV is an abbreviation of [Exposure Value].
The EV changes with the aperture value or the shutter speed.
•
If the exposure is not adequate when the shutter button is pressed halfway, the aperture value
and shutter speed turn red and blink.
•
Program Shift is canceled and the camera returns to normal Program AE Mode if more than
10 seconds pass after Program Shift is activated. However, the Program Shift setting is
memorized.
•
Program Shift will only allow adjustments to be made when there is an adequate amount of
light.
•
Program Shift is available in all [SENSITIVITY] settings except [
Basic
Program Shift
appears on the screen when Program Shift is activated.
A
1
2
2.8
4
5.6
(A)
8
11
16
22
4 2
- 43 -
A
(P138)
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14
1 1/ 2 1/ 4 1/ 8 1/ 15 1/ 30 1/ 60 1/ 125 1/ 250 1/ 500 1/ 1000 1/ 2000 1/ 4000
(B)
].
B
15
16
17
18
19
20