You can add text (comments) to pictures. After text has been registered, it can be stamped
in prints using [TEXT STAMP] (P148).
1
Select [TITLE EDIT] on the [PLAYBACK] Mode menu.
2
Press 3/4 to select [SINGLE] or [MULTI] and then press [MENU/SET].
3
Select the picture, and then press
[MENU/SET] to set.
•
['] is displayed for pictures with titles
already registered.
[MULTI] setting
Select the picture with 3/4/2/1 and
set (repeat) by pressing [MENU/SET],
then press 2 a few times to select [OK],
and execute by pressing [MENU/SET].
•
The setting is canceled when
[MENU/SET] is pressed again.
4
Enter the text.
(P121)
•
Exit the menu after it is set.
Note
•
To delete the title, erase all the text in the text input screen.
•
You can print out texts (comments) using the "PHOTOfunSTUDIO" bundled software on the
CD-ROM (supplied).
•
You can set up to 100 pictures at one time with [MULTI].
•
Title editing is disabled during the following conditions:
–
Motion pictures
–
Pictures taken with [
–
Pictures recorded with other equipment
Playback/Editing
[TITLE EDIT]
Press 2/1 to select
the picture.
], [
] or [
]
- 147 -
(P57)
[SINGLE]
Press 3/4/2/1 to
select the pictures.
[MULTI]