HP D5970A - NetServer - LCII Reference Manual page 15

Chapter 1
3. Install the Redundant Switch, if you have one, in one of the configurations
shown in Appendix B.
9. Mount Component in the Rack
Plan Component Locations
Use the original ordering information to locate where each component goes in the
rack.
If the original ordering information is not available, use HP rack configuration
tools to plan the location of each component.
HP NetServer rack configuration tools (for instance, HP Rack Assistant) make
ordering easier and automatically check that orders are complete. These tools can
be found on the HP web site. Use the Search function with the words "rack
configuration tools" at the following URL:
http://www.hp.com/go/netserver
Look for "Ordering NetServers," "Select a Configuration," "Configuration
Software," or "Rack Assistant."
Mount Each Unit in the Rack Enclosure
1. Position each unit following the original layout used to order the server.
Follow the instructions which accompany each component. If you do not
have the original layout, you can use HP rack configuration tools, available
at HP's web site, to regenerate it.
2. Rack-optimized HP NetServers and mass storage units have instructions in
their user or installation guides for mounting the units in the rack
enclosure. For other servers and storage units, rack mounting instructions
are included with optional rack-mount kits, if available. See the user or
installation guide or rack-mount kit instruction sheet which accompanies
your unit for details.
CAUTION
To prevent rack tip-over, extend or bolt on the anti-tip foot
before installing units on sliding members. Also prevent rack
tip-over by extending only one piece of equipment at a time
from the front or rear of the rack.
3. You may already have installed the UPS, Redundant Switch, and Power
Distribution Units. Do so now if you have not. Begin at the bottom of the
rack, installing the rack mount kit for the first component just above the
power components. Configuration information and examples are available
in Chapter 2 and 3.
Preparation for Cabling the HP NetServer LC 2000r
11