Hp Storage System/6 Setup - HP D5970A - NetServer - LCII Configuration Manual

HP Storage System/6 Setup

This section describes how to prepare the HP Storage System/6 for cluster operations by:
Configuring the internal cabling on the HP Storage System/6.
Assigning SCSI IDs for the disks in the HP Storage System/6 using DIP switches.
Access the Cabinet Interior
Before connecting the disks housed in the HP Storage System/6, set up the internal cables to support the
cluster. To gain access proceed as follows:
1. Unlock the bezel from the chassis.
2. Pull the top of the bezel forward, swinging it down to clear the retaining clips at the bottom of the
chassis. Lift the bezel away from the chassis as shown below.
3. Loosen the cover mounting screws using a flat-blade screwdriver.
The screws remain attached to the cover.
4. Swing the cover open and lift it off the chassis.
NetRAID Supplement to the HP NetServer Microsoft Cluster Installation Guide
HP Storage System/6 Cabinet with Bezel and Side Cover Removed
9