HP D5970A - NetServer - LCII Configuration Manual page 73

Microsoft cluster for server with hp a3661b model 30/fc high availability disk array
Hide thumbs Also See for D5970A - NetServer - LCII:
Table of Contents

Advertisement

.
Attach the mounting rails to the cabinet as shown (see figure 11).
c
Determine the location in the cabinet where the disk array is to be mounted. The disk array should be mounted
in the lowest position available in the cabinet.
Install two clip nuts (A in figure 11) over the two holes in the front and back cabinet columns at the height
where the left rail is to be mounted.
Mount the left rail by inserting the tabs at the front and rear of the cabinet (B in figure 9).
Install the two screws (one on the front column and one on the rear column) to anchor the rail in the cabinet
(C in figure 11).
Install the right rail in the same manner.
Figure 11. Installing mounting rails for the disk array into the cabinet
d.
Install the clip nuts.
Count up 14, 20, and 26 holes from the hole used to install the rail and slide clip nuts over these holes for the
front retaining screws. Perform these steps for both sides of the front of the cabinet, installing a total of six clip
nuts.
Count up five and six holes from the holes used to install the rear of the rails and install the clip nuts for the rear
retaining screws on both sides of the cabinet.
A
B
C
17

Advertisement

Table of Contents
loading

Table of Contents