Hp Netserver Hardware Setup; Install The Fc I/O Adapter - HP D5970A - NetServer - LCII Configuration Manual

2 – HP NetServer Hardware Setup

Install the FC I/O Adapter

1. Install the FC I/O Adapter in the PCI Slot
Install the FC I/O adapter in an appropriate PCI slot as specified in the Configuration Guide for the HP NetServer.
Installation steps are shown for both vertical and horizontal installations. Install a FC I/O adapter in each HP NetServer
in the cluster.
a. Make sure the HP NetServer is powered down.
b. Remove the chassis cover.
c. Locate the correct PCI expansion slot in the system.
d. Remove the expansion slot cover. Save the slot cover screw.
e. Insert the FC I/O adapter into the slot. Push the adapter into the slot until it clicks into place (see figure 1).
Vertical
Installation
f. Replace the slot cover screw.
Figure 1. Installing the FC I/O adapter
6
Horizontal
Installation