Install Additional Memory; Install All Accessory Boards - HP NetServer LH 3 Installation Road Map

7

Install Additional Memory

Use only HP DIMMs listed in HP Information
NOTE
Assistant or in HP Order Assistant.
System Board
DIMM Socket 0
DIMM Socket 1
DIMM Socket 2
DIMM Socket 3
as described in panel 6, "Removing and
1. Remove cover 3
Replacing the Covers."
2. Install the DIMMs
Choose a socket into which you want to install a DIMM. DIMMs
may be installed in any combination, in any socket.
Spread the two retaining clips on the socket outward.
8

Install All Accessory Boards

For a list of boards HP has tested, see Help
NOTE
topic "Tested Parts List" on the HP Navigator
CD-ROM.
as described in panel 6: "Removing and
1. Remove cover 1
Replacing the Covers."
2. Read the documentation
board. Follow any special instructions and installation
recommendations. Some boards have preferred slot locations. If
not, consider the boot order (see below) when choosing the
accessory board socket in which to install the board.
3. Remove the slot cover
for future use. If you are installing any full-length PCI boards, also
remove the accessory board retainer. Push on the button on the
retainer to release it, and then slide it out of the board guide.
4. Install the boards:
fasten the board's mounting screw at the slot opening at the rear of
the chassis. Connect any required cables to the boards. If you
removed the board retainer, reinstall it.
If you install an ISA non-Plug-and-Play board,
NOTE
you must reserve system resources (some or
all of: memory addresses, I/O addresses,
IRQs, and DMA channels) for it. Write down
that information now for reference when you
reserve system resouces in Section 12:
"Configure the HP NetServer."
Boot Device Priority
Boot order for PCI controllers is determined by slot location. The
system searches for a bootable device in the following order:
1. IDE CD-ROM drive with a bootable CD-ROM.
2. Flexible disk drive with a bootable flexible disk.
3. Embedded SCSI controller or embedded DAC.
4. PCI boards in slots in the following order: 8, 7, 6, 5, 4, 3, 2, 1.
This boot order can be changed using the SETUP utility
(press [F2] during the boot process).
All manuals and user guides at all-guides.com
(refer to figure at right):
included with each accessory
for each slot to be used, and store it
Insert each board in the desired slot and
Slot 1 16-bit ISA or 32-bit PCI
Slot 2 32-bit PCI
Slot 3 32-bit PCI
Slot 4 32-bit PCI
Slot 5 32-bit PCI
Slot 6 32-bit PCI
Slot 7 32-bit PCI
Slot 8 32-bit PCI
Align the notches on the DIMM with the keys on the socket.
Holding the DIMM at 90 degrees to the system board, press the
DIMM fully into the socket until the retaining clips close. If the clips
do not close, the DIMM is not inserted correctly.
3. Replace the cover(s):
accessories, install the cover(s) as described in panel 6,
"Removing and Replacing the Covers."
Accessory Board
Guide
Release Tab
Accessory
Board
Retainer
An accessory board can be identified by the offset of the bracket
and the shape of the edge connector:
DIMM
Notches
Keys
Retaining Clips
If you are not installing any other
PCI Board- Left-Side Offset
ISA Board- Right-Side Offset