HP Z600 - Workstation - 6 GB RAM User Manual page 49

Pull up on the handle (1), slide the
cover 1/2-inch toward the rear of the
system (2), then rotate the cover off the
chassis (3).
4. Remove the expansion card clamp or support as shown in the following illustrations, as applicable.
Some Z400s use a hold down clamp; grasp the top of the
clamp (1), squeeze the release handles on the side of the
clamp until the bottom of the clamp releases from the clamp
rail (2), then swing the clamp out from the back panel (3).
Lift the release tab (1), and then lift the expansion card support handle (2) to remove the expansion card support.
5. Remove the memory and system fans as shown in the following illustrations, if applicable.
ENWW
Z400
Lift the side access panel handle (1),
and remove the side access panel (2).
Z600
Z400
Some Z400s have a card support. Remove the card
support screws (1), and then lift the expansion card support
from the chassis (2).
Z800
Preparing the workstation for component installation
Z800
Lift the side access panel handle (1),
and remove the side access panel (2).
41