HP Z600 - Workstation - 6 GB RAM User Manual page 59

To install a PCI or PCIe expansion card:
1. Follow the procedures described in
workstation for component installation.
2. Align the card keyway with the slot key, and then firmly seat the card in the slot as shown in the
following illustration (1).
Figure 8-1
3. Close the retention clamp by rotating it downward (2) as shown in the illustration above.
NOTE:
retention clamp is secured by the PCI Card Support.
4. Connect all necessary power and interface cables to the card (follow instructions that came with
the expansion card).
5. Replace all components removed in preparation for component installation.
ENWW
Installing an expansion card
For the Z800, close the PCI retention clamp to make sure all cards are seated. The
Preparing for component installation on page 40 to prepare the
Installing an expansion card 51