Step 1-Preparing The Workstation - HP Z210 Series Rack Mounting Instructions

Step 1—Preparing the workstation
NOTE:
All illustrations are examples only. Workstation models vary. For product-specific information,
see the service guide for your HP workstation at
beginning installation.
To prepare the workstation for component installation:
1. Power down the workstation, and then disconnect the power cord.
2.
Power down all external devices, and then disconnect them from the workstation.
Step 2—Mounting the rails to the rack
1.
Attach the rails to the rack. See Appendix A for installation instructions.
2. If glide strips were not factory-installed, then apply them to the rail shelf.
a.
Remove the adhesive backing from the back of the glide strips.
b.
Apply a glide strip to the top surface of each rail.
Figure 1
ENWW
Applying glide strips
http://www.hp.com/support/manuals
Step 1—Preparing the workstation
before
3