Lexmark Optra T Reference page 51

Table 2-21: Page Control (Continued)
Command / Parameters
l
ESC
& #L
0 Off
1 On (Default)
ESC
&k#H
# = number of 1/120 inch increments
(Valid to 4 decimal places)
l
ESC
& #C
# = number of 1/48 inch increments
(Valid to 4 decimal places)
Default = 8
l
ESC
& #D
1 1 line/inch
2 2 lines/inch
3 3 lines/inch
4 4 lines/inch
6 6 lines/inch (Default)
8 8 lines/inch
12 12 lines/inch
16 16 lines/inch
24 24 lines/inch
48 48 lines/inch
ESC
&a#G
0 Next Side
1 Front Side
2 Back Side
2-40
Function / Result
Skip Perforation
Perforation area includes the area from the bottom margin of the
current page to the top margin of the next page. When skipping
perforations, a line feed past the bottom margin ejects a page and
places the cursor at the top margin of the next page.
Set Horizontal Motion Index (HMI)
Sets the width of all characters for fixed-space fonts. Sets only the
width of the space for proportional spaced fonts.
Set Vertical Motion Index (VMI)
Sets Vertical Motion Index in 1/48 inch increments. The VMI
determines the vertical distance between lines.
Notes:
• For some printers, you can change the default VMI from the printer
operator panel or through MarkVision by using the
menu item. Refer to your printer user documentation for more
information.
• Use of this command alters any previous Set Line Spacing
command settings.
Set Line Spacing (Alternative Method)
Specifies VMI in lines per inch.
Notes:
• For some printers, you can change the default VMI from the printer
operator panel or through MarkVision by using the
menu item. Refer to your printer user documentation for more
information.
• Unsupported values are ignored.
• Use of this command alters any earlier VMI setting.
Duplex Page Side Selection
Specifies which physical page side to print next when duplex printing.
Note: When the duplex option is not installed, this command causes a
conditional page eject.
PCL
Lines Per Page
Lines Per Page