Installing Blades - HP Xw460c - ProLiant - Blade Workstation Setup And Installation Manual

To install a power supply:
Slide the HP BladeSystem Insight Display to the right or left to gain access to all power supply bays.
1.
Open the power supply bracket.
2.
Insert the power supply into the enclosure, and close the bracket.
3.
Check the power supply LEDs (on page 14) to determine the status of the power supply.
To calculate how many power supplies are needed, see the HP BladeSystem Power Sizer
(http://www.hp.com/go/bladesystem/powercalculator).

Installing blades

The c7000 enclosure is divided into four quadrants by the vertical support metal work. Within each
quadrant, a removable divider supports half-height blades. To install a full-height blade in any quadrant,
this divider must be removed. Therefore, a quadrant can only contain either full-height blades or half-
height blades.
Installation 31