HP Xw460c - ProLiant - Blade Workstation Setup And Installation Manual page 60

On the right side: To install the power cord retention bracket on the right side of the enclosure,
o
ensure the power cord retention tabs are located on the left side of the snap clamps.
Place the power cord retention bracket under the power cords, and then align the power cords with
7.
the snap clamps.
Open the snap clamps, and then insert each power cord inside each clamp.
8.
Slide the power cord retention bracket until the bracket touches the enclosure.
9.
Insert the power cord retention tabs into the slots on the enclosure until they snap into place.
10.
Cabling and powering up the enclosure 60