Installing Interconnect Modules - HP Xw460c - ProLiant - Blade Workstation Setup And Installation Manual

Connect a USB mouse (2) and keyboard (3) to the USB hub (4).
3.
To connect the HP Onboard Administrator with KVM to an HP Server Console Switch or an HP IP Console
Switch:
Connect the KVM interface adapter (2) to the VGA connector (4) and the USB connector (3) on the
1.
HP Onboard Administrator with KVM.
Connect a CAT5 cable (1) to the KVM interface adapter (2) and an optional HP Console Switch (5).
2.

Installing interconnect modules

There are eight single-wide interconnect bays in the enclosure. Interconnect bays 1 and 2 are reserved for
Ethernet switches. Installation into the remaining interconnect bays depends on the type of mezzanine
card installed in the server and in which mezzanine slot the mezzanine card was installed.
IMPORTANT:
installation does not coincide with the mezzanine card installation, the ports on the
interconnect module will not function.
If the mezzanine card is not installed properly or the interconnect module
Installation 47