Close the hinges, and tighten the thumbscrews to secure the rear cage.
4.
Component installation
The following sections contain installation instructions for the individual enclosure components. All
components must be installed and cabled before you power up the enclosure. There is no specific
installation order requirement for the enclosure components.
Installing a power supply
See "Running the Insight Display installation steps (on page 64)" for information on the types of power
configurations available and how to set them up.
If your HP BladeSystem c7000 Enclosure is equipped with a three-phase power configuration, six power
supplies are required. Single-phase configurations can have fewer than six power supplies.
Install the power supplies based on the total number of supplies needed:
•
Two power supplies: Bays 1 and 4
•
Three power supplies: Bays 1, 2, and 4
•
Four power supplies: Bays 1, 2, 4, and 5
•
Five power supplies: Bays 1, 2, 3, 4, and 5
•
Six power supplies: All bays
Install power supply blanks in any unused power supply bays.
Power supplies are installed in this manner to provide maximum flexibility for redundancy in three-phase
configuration options.
NOTE:
configuring DC power supplies or HP Carrier Grade Solutions, see the documentation that
came with your power supply.
This document discusses installation of AC power supplies only. For information on
Installation 30