Setting Up Your X2000 Linux Workstation; Installation Tools; Connecting Devices - HP Workstation x2000 Getting Started Manual

Linux workstation

Hide thumbs Also See for Workstation x2000:

Table of Contents

WARNING

Setting Up and Using Your Linux Workstation

Setting Up Your x2000 Linux Workstation

If you have any doubt that you can lift the Workstation and

monitor safely, do not try to move them without help.

1. When you receive your Workstation, verify that you have all of the

components as shipped.

2. Place the Workstation in an area with easily accessible power outlets

and enough space for the keyboard, mouse, and any other accessories.

3. Position the Workstation so that its rear connectors are easily

accessible.

No tools are required to set up your Workstation. However, if you plan to

install or replace an accessory inside your Workstation, you will need a

T-15 Torx screwdriver and a ﬂat-blade screwdriver.

Before connecting any cords or cables to your Workstation, please read

the Warning Notices in the Preface of this manual.

If you purchased a graphics card that was not installed in your

Workstation at the factory, you must install that card now. To install,

refer to the instructions that came with the card or see the x2000

Technical Reference/Troubleshooting Guide available at:

http://www.hp.com/workstations/support.

Chapter 1

Table of Contents