Notice For Canada (Industry Canada) - HP Tc2110 - Server - 128 MB RAM Installation And Configuration Manual

Hp server ultra3 scsi host bus adapter

Hide thumbs Also See for Tc2110 - Server - 128 MB RAM:

Maintenance manual (118 pages)

Installation manual (65 pages)

Information manual (20 pages)

Table Of Contents

Table of Contents

Appendix C

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, correct the interference by one or more of the

following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a power circuit different from that to

which the receiver is connected.

Consult the dealer or an experienced radio/television technician for help.

Hewlett-Packard's system certification tests were conducted with HP-supported

peripheral devices and HP shielded cables, such as those you receive with your

server. Changes or modifications not expressly approved by Hewlett-Packard could

void the user's authority to operate the equipment. Cables used with this device must

be properly shielded to comply with the requirements of the FCC.

Class A Equipment

This equipment has been tested and found to comply with the limits for Class A

digital devices, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference when the equipment is

operated in a commercial environment. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the

instructions manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful

interference in which case the user is required to correct the interference at their own

expense.

Class A Accessories

Installation and use of a Class A accessory creates a system that meets the

requirements for industrial and commercial environments. If you are installing a

class A accessory in a system that has been labeled as a class B product, the

requirements and notice for class A equipment shall be applied.