Using Advanced Configuration Parameters; Upgrading An Existing Windows Nt Version 4 Installation To Windows 2000; Using Windows 2000 Scsi Parameters - HP Tc2110 - Server - 128 MB RAM Installation And Configuration Manual

Chapter 4
Upgrading an Existing Windows NT Version 4
Installation to Windows 2000
1. With your operating system started, insert your Windows 2000
CD-ROM and choose to upgrade your system. Your system will reboot.
2. The Windows 2000 Setup program will start. Press F6 when this message is
displayed:
Press F6 if you need to install a third party SCSI or
RAID driver...
3. Follow the directions from
Windows 2000"

Using Advanced Configuration Parameters

Advanced users may use software parameters to alter the configuration of the
Windows 2000 device drivers supplied by HP. All Windows 2000 configuration
information is stored in a data structure supplied by Windows 2000, called the
Registry. You can edit this information through a tool called the Registry Editor.
CAUTION

Using Windows 2000 SCSI Parameters

Follow the instructions below to enter the registry values that affect how the
Windows 2000 SCSI manager interprets the generic configuration information of
SCSI device drivers. Each driver has its own key reference in the registry. In this
example, the Ultra160 key is used (adpu160m). The other keys are aic78xx, aic78u2,
adf6u160, and 2930u2. All SCSI host adapters supported by the modified key are
affected by the values you enter here. A list of valid values follows:
NOTE
"Installing the Driver When Installing
on page 31.
Do not edit your registry unless it is absolutely necessary. If
there is an error in your registry, your computer may become
nonfunctional.
The following value keys are case-sensitive and must be
entered exactly as shown.
Microsoft Windows 2000 Installation
33