Bit Mask Options - HP Tc2110 - Server - 128 MB RAM Installation And Configuration Manual

Chapter 5
Table 5-1. adpt160m.ham Command Line Options
Option
multlun_targets=
slot=
verbose=
1
Many multiple-LUN and removable-media devices are changers or magazines. Some of these are only
supported by the driver through an ASPI driver provided by the hardware vendor.
2 The values can vary and are dependent on the system configuration.

Bit Mask Options

Use the example below as an aid for calculating bit mask option hex values. Each
SCSI device is enabled by a 1 in its corresponding bit position. The table that follows
the figure lists the binary-to-hex conversions. Using this example, if you want to
enable scanning for LUNs 0, 2, and 6 on all targets, then use the command line
option of lun_enable=0045.
Values Default
0-FFFF FFFF
0
2
0-xxxx
yes, no no
Novell NetWare Installation
Description
A bit mask to enable LUNs on
selected targets. By default,
LUNs on all targets are enabled.
This bit mask is entered in hex
(see "Bit Mask Options"
page 49).
Defines a physical slot number
for the host adapter. If 0 is
specified, or if this option is not
specified, then the driver loads
for all Ultra3 host adapters.
Displays host adapter
configuration information at load
time.
on
49