Microsoft Windows Nt Installation; Installing The Driver When Installing Windows Nt; Completing A Fresh Windows Nt 4.0 Installation From Floppy Disk - HP Tc2110 - Server - 128 MB RAM Installation And Configuration Manual

3 Microsoft Windows NT Installation

This chapter explains how to install the HP Ultra3 Family Manager Set driver <File
Name>adpu160m.sys for Windows NT.
If you are performing a first time Windows NT installation, see
Driver When Windows NT is Already Installed"
is already installed in your system, see
Already Installed"
Installing the Driver When Installing
Windows NT
The <File Name>adpu160m.sys driver is not embedded on the Windows NT 4.0
installation disks (or CD-ROM) and must be added during Windows NT installation.
Completing a Fresh Windows NT 4.0 Installation From Floppy
Disk
1. Start your system with the Windows NT Boot Disk in the floppy disk drive.
2. When prompted, insert disk #2 in your floppy disk drive. After a few moments
you will see a blue screen. To set up Windows NT now, press Enter.
3. Press S to skip auto-detection of your SCSI host adapter.
4. Press S again to specify an additional device.
5. Press Enter to select Others; insert the HP Ultra3 Family Manager Set disk for
Windows NT into your floppy disk drive.
6. Using the arrow keys, select the following driver and press Enter:
Adaptec Ultra3 PCI SCSI Controller (NT4.0)
7. To add other host adapters, press S and repeat from
adapter and insert the appropriate driver disk.
8. Press Enter to continue with the Windows NT operating system setup. Follow
the instructions on-screen and in the Windows NT documentation to complete
the installation.
"Installing the Driver When Windows NT is
on page 20.
"Installing the
in the next section. If Windows NT
Step 5 for each additional
19