Starting Scsiselect; Exiting Scsiselect; Using Scsiselect Settings - HP Tc2110 - Server - 128 MB RAM Installation And Configuration Manual

Chapter 2

Starting SCSISelect

Follow these steps to start SCSISelect:
1. Turn on or restart your system.
During the startup process, pay careful attention to the messages that appear on
your screen.
2. When the following message appears on your screen, press the Ctrl-A keys
simultaneously (this message appears for only a few seconds):
Press <Ctrl><A> for SCSISelect (TM) Utility!
3. From the menu that appears, use the arrow keys to move the cursor to the option
you want to select, then press Enter.
NOTE

Exiting SCSISelect

Follow these steps to exit SCSISelect:
1. Press Esc until a message prompts you to exit (if you changed any settings, you
are prompted to save the changes before you exit).
2. At the prompt, select Yes to exit, then press any key to reboot the computer. Any
changes made in SCSISelect will take effect the next time the computer is
booted.

Using SCSISelect Settings

To select an option, use the arrow keys to move the cursor to the option, then press
Enter.
In some cases, selecting an option displays another menu. You can return to the
previous menu at any time by pressing Esc.
To restore the original SCSISelect default values, press F6 from the main
SCSISelect screen.
If you have difficulty viewing the display, press F5 to toggle
between color and monochrome modes. (This feature may not
work on some monitors.)
Configuration with SCSISelect
13