Figure 1-39 Installing A Pci Card - HP Rp3440-4 - 9000 - 0 MB RAM Installation Manual

Failure to observe this warning can result in personal injury or damage to
equipment.
CAUTION Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD
safety precautions can result in damage to the server.
Carefully read the following information concerning PCI slot configuration. Inserting a PCI card into a slot
that is not configured to accept it can cause operation failure or the PCI card to operate at less than optimum
speed. PCI slots are numbered 1 (top of card cage) through 4 (bottom of card cage). See the labels on the rear
panel of the chassis for correct PCI slot number identification.
Installing a PCI Card
Step 1. Remove the cover. (See "Removing and Replacing the Top Cover on a Rack-Mounted Server" on
page 26.)
Step 2. Remove the PCI cage. (See "Removing the PCI Card Cage" on page 50.)
Step 3. Grasp the edges of the PCI card to be installed and evenly press the card into the PCI backplane
connector.

Figure 1-39 Installing a PCI Card

Step 4. Connect any internal cables that are required by the PCI card.
Step 5. Install the accessory card holder(s) and secure in place by tightening the associated bulkhead
screw(s).
Step 6. Reinstall the PCI cage. (See "Replacing the PCI Card Cage" on page 52.)
Step 7. Replace the cover. (See "Removing and Replacing the Top Cover on a Rack-Mounted Server" on
page 26.)
Chapter 1
Installing the System
Installing Additional Components
53