Control Panel; Figure 1-5 Front View - HP Rp3440-4 - 9000 - 0 MB RAM Installation Manual

Installing the System
Introduction
• If installing a hot-pluggable component, complete the required software intervention prior to removing
the component.
• If installing an assembly that is neither hot-swappable, nor hot-pluggable, disconnect the power cable
from the external server power receptacle.
WARNING Ensure that the server is powered off and all power sources are disconnected from
the server prior to removing or installing server hardware unless you are removing
or installing a hot-swappable or hot-pluggable component.
Voltages are present at various locations within the server whenever a dc power
source is connected. This voltage is present even when the main power switch is
turned off.
Failure to observe this warning can result in personal injury or damage to
equipment.
• Do not wear loose clothing that can snag or catch on the server or on other items.
• Do not wear clothing subject to static charge build up, such as wool or synthetic materials.
• If installing an internal assembly, wear an antistatic wrist strap and use a grounding mat, such as those
included in the Electrically Conductive Field Service Grounding Kit (HP 9300-1609).
• Handle accessory boards and components by the edges only. Do not touch any metal-edge connectors or
any electrical components on accessory boards.

Control Panel

The control panel of the HP 9000 rp3410 or rp3440 server provides the controls and indicators commonly used
for operation.
Figure 1-5 Front View
HDD 3
HDD 2
HDD 1
18
Control Panel
System Product
Label (pull-out)
DVD Drive
Chapter 1