Table 1-16. System Led States - HP Rp3440-4 - 9000 - 0 MB RAM Installation Manual

Power and System LEDs
The power and system LEDs indicate the state of the system. When the system LED is blinking yellow or red,
a problem exists.
Table 1-16 provides system LED states.
Table 1-16 System LED States
System LED
Off
Solid green
Blinking green
Blinking yellow (1/sec.)
Blinking red (2/sec.)
For system alerts of levels 3–5, you can clear the attention condition on the LED by accessing the logs using
the sl command available in the iLO MP command mode.
You can clear the fault condition for system alerts of level 7 by resolving the problem and cycling power. See
the SL error logs for additional error information.
Always check the iLO MP status logs in the case of a blinking yellow or red system LED before
NOTE
replacing any hardware.
LAN LEDs
The front panel LAN LED indicates the system is communicating over the Gigabit or system management
LAN:
• Blinking green: the system is communicating over the LAN.
• Solid green: LAN link is established; no current LAN activity.
• Not green: no LAN cable attached; LAN network dead or the system is off.
10/100/1000 LAN LEDs are on the rear panel.
Chapter 1
ac power is off if power LED is off.
Running OS.
Booting or running BCH.
Attention:
Alerts of levels 3–5 detected in the iLO MP logs.
The LED turns off once the event log has been read.
Fault:
System Alert 7 detected, LED blinks until the problem is resolved and
the system boots successfully .
Fatal hardware error detected by BMC, LED blinks until problem is
corrected.
State
Installing the System
Troubleshooting
91