2.10 Optical Drive Troubleshooting
Procedure 5
Connection check and replacement check
The optical drive connects to the system board. The drive may be disconnected, or the drive or
system board may be damaged. Disassemble the computer following the steps described in
Replacement Procedures
Chapter 4,
Check 1
Make sure the drive is firmly connected to the system board. If the connection is
good and there is still an error, go to Check 2.
Check 2
The drive or drive cable may be defective or damaged. Replace each with a new one
following the steps in Chapter 4,
functioning properly, perform Check 3.
Check 3
The system board may be damaged. Replace it with new one following the
instructions in Chapter 4, Replacement Procedures.
Satellite A110/Series Maintenance Manual
, and perform the following checks:
Replacement Procedures
[CONFIDENTIAL]
2 Troubleshooting Procedures
. If the drive is still not
2-29