Toshiba Satellite A110 Maintenance Manual page 142

4.19 LCD Module
4. Remove eight M2x3 black screws securing the LCD module bracket to the LCD module.
5. Lift it out.
NOTE: If the LCD module malfunctions, remove the LCD cable and LCD
bracket. Then replace the whole LCD module unit.
Installing the LCD Module
To install the LCD module, follow the steps below and refer to the figures in the preceding
section.
1. Set the LCD module in the display assembly with the LCD module bracket and eight
black M2x3 screws. Secure the LCD module with two black M2.5x6 screws.
2. Connect the two connectors on either side of the FL inverter board.
3. Secure one M2.5x3 black screw holding the LCD cable in place.
Detroit 20 /Detroit 20E Series Maintenance Manual
Figure 4-41 Removing the bracket screws
4 Replacement Procedures
[CONFIDENTIAL] 4-37