Replacing The Front Fan Assembly - Lenovo J200 Hardware Maintenance Manual

Replacing the front fan assembly

This procedure describes how to remove and replace the front fan assembly.
1. Remove the computer cover. See "Removing the cover" on page 123.
2. Remove the front bezel. See "Removing and replacing the front bezel" on page
3. Note the routing of the front fan cable to the system board. Disconnect the
4. The fan assembly is mounted with four rubber mounts that protrude through
5.
128.
front fan assembly cable from the system board. See "Locating parts on the
system board" on page 125.
the front of the chassis. Remove the fan assembly by pulling the rubber mounts
back through the chassis.
Install the new front fan assembly by aligning the rubber mounts of the front
fan assembly with the holes on the chassis and push the rubber mounts
through the holes.
Chapter 9. Replacing FRUs - Tower Computers
157